Tuesday, July 23, 2013

Assembling a Forgeworld AX-1-0 Tigershark

While working on my current Tau project I am in tandem working on an Apocalypse model for the army.  I really enjoyed having the Baneblade and Shadowsword for my IG army, the titan for my Chaos, so when I decided to do Tau I knew I wanted at least one Apocalypse model to run with it. I decided on the AX-1-0 Tigershark since D-Weapons are awesome. 

This model turned out to look really easy but be more of a pain than I thought it would be.  For one thing, the mold channels go into areas that are exposed flat areas of the back of the craft so a ton of filing needs to be done so it looks right.  They also were a pain to cut off since they were so think.  A dremel works but it makes a big mess (even using a vacuum). 

As I mentioned a few weeks ago (and detailed in this post) I mounted the model using a Secret Weapon Miniatures base and flying stand. After that was done I began the assembly process.  I spent a few hours every few days over about two weeks.  It wasn't the hardest project I've done though it turned out to be more intensive than I thought looking at the pieces.

The first thing to do was to start filing down the model so the engines could fit on the back.  As you can see from the below picture quite a bit of file work was needed to make the housings and four engines fit. 



 A clamp was super helpful to ensure that the housing sat flush with the not exactly flat surface I filed down.
 
 

 After a lot of dry fitting and filing I was able to get all four engines and their mounts installed. 



 Like all Forgeworld models some of the pieces were warped.  For this model it wasn't too bad, it really was only the Railguns.  Some hot water got them most of the way there.


 I did run into one major problem.   While attempting to install the cockpit/escape pod, which slides into place, it got stuck about halfway into position.  I am still not sure how this happened after many dry fittings.  It is much better to slide it into place and then put a couple of  drops into the cracks to glue in place than put glue on it before sliding.

I tried to use a mallet to gently push the assembly back out but this ended up just damaging the back of the cockpit assembly.  Luckily this part will end up being covered, though it was hugely frustrating, to say the least.  After realizing it wouldn't budge I figured an overnight soak in Simple Green would be the only way to get it out, by breaking up the glue.  I didn't want to redo the entire model, so I managed to MacGyver a setup that only soaked the needed area. Sure enough, after about 24 hours, with a little prying, it popped right out and I could get back to assembly.


  

 I only had a few pieces to install and the model is basically done.  The rail guns are just sitting in place, since I'd like to pain them separately (otherwise I can't get camo masking on the inner engine housings.



3 comments:

  1. This comment has been removed by the author.

    ReplyDelete
  2. Do you happen to have the build instructions? I have the parts to build my own, just no instructions.

    ReplyDelete
  3. Wow :)
    This is an incredible collection of ideas!
    Waiting for more helpful pieces.
    You would amazing to read a similar one here-
    bestofcleaner.com

    ReplyDelete